Reinstalling Scbs; Figure 83: Installing The Fan Tray - Juniper SRX 5600 Hardware Manual

SRX 5600 Services Gateway Hardware Guide
2.
3.

Figure 83: Installing the Fan Tray

Reinstalling SCBs

To reinstall an SCB, follow this procedure for each SCB (see Figure 84 on page 211):
CAUTION: Before removing or replacing an SCB, ensure that the ejector handles are
stored vertically and pressed toward the center of the SCB.
1.
2.
3.
4.
5.
210
Reinstalling Components in the Chassis
Grasp the fan tray on each side and insert it straight into the chassis. Note the
correct orientation by the "this side up" label on the top surface of the fan tray.
Tighten the captive screws on each side of the fan tray faceplate to secure it in
the chassis.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see "Preventing Electrostatic Discharge Damage" on page 152.
Carefully align the sides of the SCB with the guides inside the chassis.
Slide the SCB into the chassis, carefully ensuring that it is correctly aligned.
Grasp both ejector handles and rotate them simultaneously clockwise until the
SCB is fully seated.
Place the ejector handles in their proper position, horizontally and toward the
center of the board.