Maintaining Hardware Components; Tools And Parts Required; Routine Maintenance Procedures - Juniper SRX 5600 Hardware Manual

Chapter 11

Maintaining Hardware Components

Tools and Parts Required

Routine Maintenance Procedures

This chapter describes how to maintain hardware components installed in the device.
Some components, such as the craft interface, require no maintenance.
For information about returning a part to Juniper Networks for repair or replacement,
see "Contacting Customer Support and Returning Hardware" on page 215.
Tools and Parts Required on page 79
Routine Maintenance Procedures on page 79
Maintaining Cooling System Components on page 80
Maintaining the Host Subsystem on page 81
Maintaining IOCs and SPCs on page 84
Maintaining IOC Cables on page 85
Handling and Storing Cards on page 86
Maintaining the Power Supplies on page 90
To maintain hardware components, you need the following tools and parts:
ESD grounding wrist strap
Flat-blade (-) screwdriver
Phillips (+) screwdriver, number 1
Phillips (+) screwdriver, number 2
For optimum services gateway performance, perform the following preventive
maintenance procedures regularly:
Inspect the installation site for moisture, loose wires or cables, and excessive
dust. Make sure that airflow is unobstructed around the device and into the air
intake vents.
Check the status-reporting devices on the craft interface-System alarms and
LEDs.
Tools and Parts Required
79