Juniper SRX5600 Installing

Installing the SRX5600 Services Gateway Mounting Hardware for a Rack or Cabinet
The services gateway can be installed in a four-post rack or cabinet or an open-frame
rack. Install the mounting hardware on the rack before installing the services gateway.
Install the mounting shelf, which is included in the shipping container, before installing
the services gateway. We recommend that you install the mounting shelf because
the weight of a fully loaded chassis can be up to 163.5 lb (74.2 kg).
Table 1 specifies the holes in which you insert cage nuts and screws to install the
mounting hardware required (an X indicates a mounting hole location). The hole
distances are relative to one of the standard U divisions on the rack. The bottom of
all mounting shelves is at 0.02 in. above a U division.
Table 1: Four-Post Rack or Cabinet Mounting Hole Locations
Hole Distance Above U Division
4 2.00 in. (5.1 cm)
3 1.51 in. (3.8 cm)
2 0.88 in. (2.2 cm)
1 0.25 in. (0.6 cm)
To install the mounting shelf on the front rails of a four-post rack or cabinet, or the
rails of an open-frame rack (see Figure 1 or Figure 2):
If needed, install cage nuts in the holes specified in Table 1.
1.
On the back of each rack rail, partially insert a mounting screw into the lowest
2.
hole specified in Table 1.
Install the mounting shelf on the back of the rack rails. Rest the bottom slot of
3.
each flange on a mounting screw.
Partially insert the remaining screws into the open holes in each flange of the
4.
mounting shelf.
Tighten all the screws completely.
5.
Installing the SRX5600 Services Gateway Mounting Hardware for a Rack or Cabinet
Mounting Shelf
1.14 U
X
0.86 U
X
0.50 U
X
0.14 U
X
1