Flex I/O Card (Srx5K-Fpc-Ioc) Specifications - Juniper SRX5400 Hardware Manual

Flex I/O Card (SRX5K-FPC-IOC) Specifications

The SRX5K-FPC-IOC Flex I/O card (Flex IOC)
port modules that add Ethernet ports to your services gateway. A Flex IOC with installed port modules
functions in the same way as a regular IOC, but allows greater flexibility in adding different types of Ethernet
ports to your services gateway.
Each Flex IOC has a processor subsystem, which includes a 1.2-GHz CPU, a system controller, 1 GB
SDRAM, and two Packet Forwarding Engines with a maximum throughput of 10 Gbps each.
You must install at least one IOC in the services gateway. The IOC can be of any of the available IOC or
Flex IOC types.
You can install Flex IOCs in any of the slots that are not reserved for Switch Control Boards (SCBs). If a
slot is not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling
air to circulate properly through the services gateway.
Figure 61: Flex IOC with Typical Port Modules
Flex IOC
4x10GE-XFP
port module
in slot 0
16x1GE-TX
port module
in slot 1
Description
Software release
Cables and connectors
Controls
Supported Slots
(Figure 61 on page
Flex IOC with slots for two port modules
Maximum throughput: 10 Gbps (per PFE)
Junos OS Release 9.5R1 and later
Slots for two port modules
None
SRX5600–Any slot except bottom slots 0 or 1
SRX5800–Any slot except center slots 0, 1, or 2/6
137) is an IOC with two slots that accept
137