Disconnecting The Alarm Relay Wires; Figure 42: Installing A Craft Interface; Figure 43: Alarm Relay Contacts - Juniper SRX 5600 Hardware Manual

5.
6.

Figure 42: Installing a Craft Interface

Replacing Alarm Relay Wires
The alarm relay wires connect external alarm-reporting devices to the
YELLOW
The terminal blocks that plug into the alarm relay contacts are supplied with the
services gateway. The terminal blocks accept wire of any gauge between 28-AWG
and 14-AWG (0.08 and 2.08 mm
device you are connecting.

Figure 43: Alarm Relay Contacts

Disconnecting the Alarm Relay Wires

To disconnect the alarm relay wires from the services gateway and an alarm-reporting
device (see Figure 43 on page 103):
1.
2.
Tighten the screws on the left and right corners of the craft interface faceplate.
Reattach any external devices connected to the craft interface.
relay contacts on the craft interface.
Disconnect the existing wire at the external device.
Using a 2.5-mm flat-blade screwdriver, loosen the small screws on the face of
the terminal block and remove the block from the relay contact.
Chapter 13: Replacing Hardware Components
2
). Use the wire gauge appropriate for the external
Replacing the Craft Interface
and
RED
103