Powering Off The Services Gateway - Juniper SRX 5600 Hardware Manual

SRX 5600 Services Gateway Hardware Guide
NOTE: After powering off a power supply, wait at least 60 seconds before turning it
back on. After powering on a power supply, wait at least 60 seconds before turning
it off.
If the system is completely powered off when you power on the power supply, the
Routing Engine boots as the power supply completes its startup sequence. If the
Routing Engine finishes booting and you need to power off the system again, see .
After a power supply is powered on, it can take up to 60 seconds for status
indicators—such as the status LEDs on the power supply and the
command display—to indicate that the power supply is functioning normally. Ignore
error indicators that appear during the first 60 seconds.
10.

Powering Off the Services Gateway

If you need to power off the services gateway:
1.
2.
3.
70

Powering Off the Services Gateway

On the external management device connected to the Routing Engine, monitor
the startup process to verify that the system has booted properly.
On the external management device connected to the Routing Engine, issue the
operational mode command. The command shuts down the
request system halt
Routing Engine cleanly, so its state information is preserved.
user@host> request system halt
Wait until a message appears on the console confirming that the operating system
has halted. For more information about the command, see the JUNOS System
Basics and Services Command Reference.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see "Preventing Electrostatic Discharge Damage" on page 152.
On an AC-powered device, switch the AC switch on each power supply to the
off position ( O ). On a DC-powered device, switch the circuit breaker on each
power supply to the off position ( ).
OFF
show chassis