File Explorer - Agilent Technologies 4000 X-Series User Manual

File Explorer

The File Explorer lets you navigate the oscilloscope's internal file system
and the file systems of connected USB storage devices.
From the internal file system, you can load oscilloscope setup files or
mask files.
From a connected USB storage device, you can load setup files, mask files,
license files, firmware update (*.agx) files, label files, etc. Also, you can
delete files on a connected USB storage device.
The USB port on the front panel, and the USB port on the rear panel labeled "HOST" are
N O T E
USB Series A receptacles. These are the receptacles to which you can connect USB mass
storage devices and printers.
The square receptacle on the rear panel labeled "DEVICE" is provided for controlling the
oscilloscope over USB. See the Programmer's Guide for more information.
The oscilloscope's internal file system, under "\Agilent Flash", consists of
10 locations for oscilloscope setup files, four locations for mask files, and
four locations for waveform generator arbitrary waveform files.
To use the File Explorer:
1 Press [Utility] > File Explorer.
2 In the File Explorer Menu, press the softkey in the first position and
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
use the Entry knob to navigate.
20
Utility Settings
333