Table of Contents
Advertisement
Changes in Revision A.03.30 from Revision A.03.2x
As a result of the spin off from Hewlett-Packard Company, the Hewlett-Packard name
brand and HP logos will all be changed to Agilent Technologies and Agilent Technologies
logos effective November 1, 1999. From this transition period all existing documents that
refer to Hewlett-Packard will be changed to Agilent Technologies.
For VEE Program, the function to [Abort] long measurement has been added in the
following :
•
[BER] (without optimize) test of the bit error measurement
•
[747] test of the bit error measurement
•
[Bath Tub] test of the bit error measurement
•
Popcorn Noise measurement
•
Spectral SNR measurement
•
Spectrum Measurement
The number of sequences that can be setup have been increased from 25 to (approximately)
50 sequences. This depends on the measurement sequence.
Motion program enhancement, this eliminates unnecessary noise pops during home and
measurement positions.
The spinstand firmware should be downloaded from the installer when you upgrade
software Rev3.21 to Rev3.30.
Importing the library and including declaration file for software Rev3.30 and later
revisions.
When you update the system software the new destination directory for Rev 3.30 will be
C:\Program Files\Agilent\E5022. In line with this the set PATH of the "autoexec.bat" will
be changed. In addition the path name of the import library of E5022A VEE will also be
changed. Before you install software Rev3.30 it is recommended that you uninstall
Rev3.21. However, when you uninstall Rev3.21and earlier revisions, use the installer
process to uninstall. ". Do not use the "Control Panel>>Add/Remove Program" icon or any
other manual means to uninstall.
•
You must import the library file and include the declaration file at the beginning of
every program that contains Agilent Technologies E5022A function calls.
When you create your own application programs either by VEE, Visual Basic or Visual
C++, you need to do the following.
— For VEE, the file "hpe5022_32.dll" under the directory
"c:\Program Files\Agilent\E5022\bin" should be imported. The file named
"hpe5022_vee.h" under the directory "c:\Program Files\Agilent\E5022\include"
should be included as a definition file. For Rev3.30 you need to change the path
name of the "hpe5022_32.dll" and recompile the .vxe files
Appendix A
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Changes in Revision A.03.30 from Revision A.03.2x
Manual Changes
373
Advertisement
Table of Contents
