Searching for FlexRay Data in the Lister
The oscilloscope's search capability lets you search for (and mark) certain
types of FlexRay data in the Lister. You can use the [Navigate] key and
controls to navigate through the marked rows.
1 With FlexRay selected as the serial decode mode, press [Search].
2 In the Search Menu, press the Search softkey; then, turn the Entry knob
3 In the Search Menu, press Search for; then, select from these options:
For more information on searching data, see
page 146.
For more information on using the [Navigate] key and controls, see
"Navigating the Time Base"
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
to select the serial bus (Serial 1 or Serial 2) on which the FlexRay
signals are being decoded.
Frame ID — Finds frames with the specified ID. Press the Frame ID
•
softkey to select the ID.
Cycle number (+ Frame ID) — Finds frames with the specified cycle
•
number and ID. Press the Frame ID softkey to select the ID. Press
the Cycle # softkey to select the number.
Data (+ Frame ID + Cycle number) — Finds frames with the specified data,
•
cycle number, and frame ID. Press the Frame ID softkey to select the
ID. Press the Cycle # softkey to select the number. Press the Data
softkey to open a menu where you can enter the data value.
Header CRC Error — Finds cyclic redundancy check errors in headers.
•
Frame CRC Error — Finds cyclic redundancy check errors in frames.
•
Errors — finds all errors.
•
FlexRay Triggering and Serial Decode
"Searching Lister Data"
on page 75.
24
on
413