Zone Qualified Trigger - Agilent Technologies 4000 X-Series User Manual

•
•
•

Zone Qualified Trigger

The zone qualified trigger feature gives you one or two rectangular areas,
Zone 1 and Zone 2, that a waveform must either intersect or not intersect
in order for an acquisition to be displayed and stored in memory.
The zone qualified trigger feature works on top of the oscilloscope's
hardware trigger, which determines the acquisitions whose waveforms are
evaluated for zone intersection.
To set up a zone qualified trigger:
1 Touch the upper- right corner to select the rectangle draw mode.
2 Drag your finger (or connected USB mouse pointer) across the screen
3 Take your finger off the screen (or release the mouse button).
4 In the popup menu, select whether the rectangle is Zone 1 or Zone 2
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
"SPI Triggering" on page 428
"UART/RS232 Triggering"
"USB 2.0 Triggering"
to draw a rectangular zone that the waveform must either intersect or
not intersect.
and whether it is a "Must Intersect" or "Must Not Intersect" zone.
on page 463
on page 473
10
Triggers
201