Probe Cable For Digital Channels - Agilent Technologies 4000 X-Series User Manual

6
Digital Channels
2 Connect the digital probe cable to the DIGITAL Dn - D0 connector on
C A U T I O N
Use only the Agilent logic probe and accessory kit supplied with the mixed-signal
oscilloscope (see
3 Connect the ground lead on each set of channels (each pod), using a
124
Turning off power to the device under test would only prevent damage
that might occur if you accidentally short two lines together while
connecting probes. You can leave the oscilloscope powered on because
no voltage appears at the probes.
the mixed- signal oscilloscope. The digital probe cable is keyed so you
can connect it only one way. You do not need to power- off the
oscilloscope.

Probe cable for digital channels

"Accessories Available"
probe grabber. The ground lead improves signal fidelity to the
oscilloscope, ensuring accurate measurements.
on page 373).
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
Off