Agilent Technologies 4000 X-Series User Manual page 233

4 Press Source (or X1 Source, X2 Source in the Track Waveform mode); then,
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
• Track Waveform — As you move a marker horizontally, the vertical
amplitude of the waveform is tracked and measured. The time and
voltage positions are shown for the markers. The vertical (Y) and
horizontal (X) differences between the markers are shown as X and
Y values.
Measure — When measurements are displayed, this mode shows the
•
cursor locations used to make the measurement. When you add a
measurement, it becomes the one that cursors are displayed for. You
can use the Measurement softkey or touch in the Meas sidebar dialog
to select the measurement whose cursor locations are displayed.
Binary — Logic levels of displayed waveforms at the current X1 and
•
X2 cursor positions are displayed in the Cursor sidebar dialog in
binary. The display is color coded to match the color of the related
channel's waveform.
Hex — Logic levels of displayed waveforms at the current X1 and X2
•
cursor positions are displayed in the Cursor sidebar dialog in
hexadecimal.
Manual and Track Waveform modes can be used on waveforms that are
displayed on the analog input channels (including math functions).
Binary and Hex modes apply to digital signals (of MSO oscilloscope
models).
In Hex and Binary modes, a level can be displayed as 1 (higher than
trigger level), 0 (lower than trigger level), indeterminate state (- ), or X
(don't care).
In Binary mode, X is displayed if the channel is turned off.
In Hex mode, the channel is interpreted as 0 if turned off.
select the input source for cursor values.
13
Cursors
233