Base; Overshoot - Agilent Technologies 4000 X-Series User Manual

Infiniivision 4000 x-series

Hide thumbs Also See for 4000 X-Series:

Table of Contents

Measurements

Base

The Base of a waveform is the mode (most common value) of the lower

part of the waveform, or if the mode is not well defined, the base is the

same as Minimum. The Y cursor shows the value being measured.

Overshoot is distortion that follows a major edge transition expressed as a

percentage of Amplitude. The X cursors show which edge is being

measured (edge closest to the trigger reference point).

Rising edge overshοot =

Falling edge overshοot = Base − D local Minimum

local Maximum − D Top

local Maximum

local Minimum

Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide

Show Quick Links

Table of Contents