To Set Autoscale Preferences - Agilent Technologies 4000 X-Series User Manual

3 Press the Wait softkey; then, turn the Entry knob to select the number
4 Press the Preview softkey to preview the screen saver you have selected
5 To view the normal display after the screen saver has started, press any

To set AutoScale preferences

1 Press [Utility] > Options > Preferences > AutoScale.
2 In the AutoScale Preferences Menu, you can:
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
If User is selected:
a Press the Text softkey.
b In the Text keypad dialog, you can enter text using:
The touch screen (when the front panel [Touch] key is lit).
•
• The Entry knob. Turn the knob to select a key in the dialog;
then, push the
• A connected USB keyboard.
• A connected USB mouse — you can click anything on the screen
that can be touched.
c When you are done entering text, select the dialog's Enter or OK key
or press the Text softkey again.
The user- defined screen saver text appears in the softkey.
of minutes to wait before the selected screen saver activates.
When you turn the Entry knob, the number of minutes is displayed on
the Wait softkey. The default time is 180 minutes (3 hours).
with the Saver softkey.
key or turn any knob.
Press the Fast Debug softkey enable/disable this type of autoscale.
•
When fast debug is enabled, autoscale lets you make quick visual
comparisons to determine whether the signal being probed is a DC
voltage, ground, or an active AC signal.
Entry knob to enter it.
20
Utility Settings
337