Searching For Can Data In The Lister - Agilent Technologies 4000 X-Series User Manual

• CRC — cyclic redundancy check.
• Errors — highlighted in red. Errors can be Acknowledge (Ack, A), Form
Aliased data is highlighted in pink. When this happens, decrease the
horizontal time/div setting and run again.

Searching for CAN Data in the Lister

The oscilloscope's search capability lets you search for (and mark) certain
types of CAN data in the Lister. You can use the [Navigate] key and
controls to navigate through the marked rows.
1 With CAN selected as the serial decode mode, press [Search].
2 In the Search Menu, press the Search softkey; then, turn the Entry knob
3 Press Search; then, select from these options:
For more information on searching data, see
page 146.
For more information on using the [Navigate] key and controls, see
"Navigating the Time Base"
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
(Fo), or Frame (Fr). Different kinds of errors can be combined like
"Fo,Fr" in the above example.
to select the serial slot (Serial 1 or Serial 2) on which the CAN signal
is being decoded.
Remote Frame ID (RTR) — Finds remote frames with the specified ID.
•
Press the Bits softkey to enter the ID.
Data Frame ID (~RTR) — Finds data frames matching the specified ID.
•
Press the Bits softkey to enter the ID.
Remote or Data Frame ID — Finds remote or data frames matching the
•
specified ID. Press the Bits softkey to select the ID.
Data Frame ID and Data — Finds data frames matching the specified ID
•
and data. Press the Bits softkey to set the ID length, ID value,
number of data bytes, and data value.
Error Frame — Finds CAN active error frames.
•
All Errors — Finds any form error or active error.
•
Overload Frame — Finds CAN overload frames.
•
CAN/LIN Triggering and Serial Decode
"Searching Lister Data"
on page 75.
23
on
395