Mil-Std-1553 Serial Decode - Agilent Technologies 4000 X-Series User Manual

27
MIL-STD-1553/ARINC 429 Triggering and Serial Decode
For MIL-STD-1553 decode information see
N O T E

MIL-STD-1553 Serial Decode

To set up the oscilloscope to capture MIL- STD- 1553 signals, see
MIL- STD- 1553 Signals"
For MIL-STD-1553 triggering setup see
N O T E
To set up MIL- STD- 1553 serial decode:
1 Press [Serial] to display the Serial Decode Menu.
2 Use the Base softkey to select between hexadecimal and binary display
3 If the decode line does not appear on the display, press the [Serial] key
4 If the oscilloscope is stopped, press the [Run/Stop] key to acquire and
448
• The 0 1 X softkey lets you set the bit time position value as a 1, 0,
or X (don't care).
• Parity Error — triggers if the (odd) parity bit is incorrect for the data
in the word.
Sync Error — triggers if an invalid Sync pulse is found.
•
Manchester Error — triggers if a Manchester encoding error is detected.
•
of the decoded data.
The base setting is used for the display of the remote terminal address
and the data, in both the decode line and in the Lister.
to turn it on.
decode data.
"MIL-STD-1553 Serial Decode"
on page 445.
"MIL-STD-1553 Triggering"
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
on page 448.
"Setup for
on page 447.