Stand-Alone (Point-To-Point) Connection To A Pc - Agilent Technologies 4000 X-Series User Manual

20
Utility Settings
5 Configure the oscilloscope's LAN interface:
6 Connect the oscilloscope to the local area network (LAN) by inserting

Stand-alone (Point-to-Point) Connection to a PC

The following procedure describes how to establish a point- to- point (stand
alone) connection to the oscilloscope. This is useful if you want to control
the oscilloscope using a laptop computer or a stand- alone computer.
1 Press [Utility] > I/O.
2 Press the LAN Settings softkey.
3 Press the Config softkey; then, turn the Entry knob to select Automatic,
4 Connect your PC to the oscilloscope using a cross- over LAN cable such
5 Cycle power on the oscilloscope. Wait until the LAN connection is
Now, the instrument is connected, and the instrument's web interface or
remote control via LAN may be used.
332
If Automatic is not enabled, the oscilloscope's LAN configuration must
be set up manually using the Modify and Host name softkeys
a Use the Modify softkey (and the other softkeys and keypad entry
dialogs) to enter the IP Address, Subnet Mask, Gateway IP, and DNS
IP values.
b Press the Host name softkey and use the keypad entry dialog to enter
the Host Name.
c Press the Apply softkey.
the LAN cable into the "LAN" port on the rear panel of the
oscilloscope.
and press the softkey again to enable it.
If your network supports DHCP or AutoIP, enabling Automatic lets the
oscilloscope use those services to get its LAN configuration settings
as Agilent part number 5061- 0701, available on the web at
"www.parts.agilent.com".
configured:
Press [Utility] > I/O and wait until the LAN status shows "configured".
•
This may take a few minutes.
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide