I2S Triggering; In The Trigger Menu, Press The Trigger Softkey; Then, Turn The Entry Knob; Are Being Decoded - Agilent Technologies 4000 X-Series User Manual

26
I2S Triggering and Serial Decode
13 Press the SCLK Slope softkey; then, turn the Entry knob to select the

I2S Triggering

To set up the oscilloscope to capture I
Signals"
After you have set up the oscilloscope to capture I
trigger on a data value.
1 Press [Trigger].

2 In the Trigger Menu, press the Trigger softkey; then, turn the Entry knob

438
WS Low = Right Channel — Right- channel data corresponds to WS=low;
left- channel data corresponds to WS=high.
SCLK edge on which data is clocked in your device under test: either
rising or falling. The on- screen diagram changes with your selection.
on page 435.
to select the serial slot (Serial 1 or Serial 2) on which the I2S signals

are being decoded.

2
S signals, see
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
"Setup for I2S
2
S signals, you can then