To Adjust The Vertical Scale; To Adjust The Vertical Position - Agilent Technologies 4000 X-Series User Manual

Turning channels off
N O T E
You must be viewing the menu for a channel before you can turn it off. For example, if
channel 1 and channel 2 are turned on and the menu for channel 2 is being displayed, to
turn channel 1 off, press [1] to display the channel 1 menu; then, press [1] again to turn
channel 1 off.

To adjust the vertical scale

1 Turn the large knob above the channel key marked
The vertical scale knob changes the analog channel scale in a 1- 2- 5 step
sequence (with a 1:1 probe attached) unless fine adjustment is enabled
(see
page 84).
The analog channel Volts/Div value is displayed in the status line.
The default mode for expanding the signal when you turn the
volts/division knob is vertical expansion about the ground level of the
channel; however, you can change this to expand about the center of the
display. See

To adjust the vertical position

1 Turn the small vertical position knob ( ) to move the channel's
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
vertical scale (volts/division) for the channel.
You can also do this using the touchscreen. See
and Open Scale/Offset Dialogs"
"To change the vertical scale knob's coarse/fine adjustment setting"
"To choose "expand about" center or ground"
waveform up or down on the display.
You can also make this adjustment using the touchscreen. See
Waveform Offsets By Dragging Ground Reference Icons"
"Turn Channels On/Off and Open Scale/Offset Dialogs"
"Turn Channels On/Off
on page 54.
3
Vertical Controls
to set the
on
on page 335.
"Change
on page 51 and
on page 54.
81