Agilent Technologies 4000 X-Series User Manual page 34

1
Getting Started
2 If you want to return to the oscilloscope settings that existed before,
3 If you want to enable "fast debug" autoscaling, change the channels
If you see the waveform, but the square wave is not shaped correctly as
shown above, perform the procedure
page 35.
If you do not see the waveform, make sure the probe is connected
securely to the front panel channel input BNC and to the left side,
Demo 2, Probe Comp terminal.
How AutoScale Auto Scale analyzes any waveforms present at each channel and at the
Works external trigger input. This includes the digital channels, if connected.
34
press Undo AutoScale.
autoscaled, or preserve the acquisition mode during autoscale, press
Fast Debug, Channels, or Acq Mode.
These are the same softkeys that appear in the AutoScale Preferences
Menu. See "To set AutoScale preferences"
"Compensate Passive Probes"
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
on page 337.
on