14
Measurements
4 Press the Settings softkey to select the second analog channel source
5 Press the
6 Press the Add Measurement softkey to make the measurement.
The example below shows a delay measurement between the rising edge of
channel 1 and the rising edge of channel 2.
Phase
Phase is the calculated phase shift from source 1 to source 2, expressed in
degrees. Negative phase shift values indicate that the rising edge of source
1 occurred after the rising edge of source 2.
260
and slope for the delay measurement.
The default Delay settings measure from the rising edge of channel 1 to
the rising edge of channel 2.
Back/Up key to return to the Measurement Menu.
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide