Agilent Technologies 4000 X-Series User Manual page 69

Figure 3
4 Press the [Cursors] key.
5 Set the Y2 cursor to the top of the signal, and set Y1 to the bottom of
6 Move the Y1 and Y2 cursors to the intersection of the signal and the Y
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
sin =
Signal must
be centered in
" X"
D
A B
C
Measuring
phase difference
XY time mode signals, centered on display
the signal.
Note the Y value at the bottom of the display. In this example, we are
using the Y cursors, but you could have used the X cursors instead.
axis. Again, note the Y value.
Signals 90 degrees
out of phase
Horizontal Controls
Signals
in phase
69
2