Show Interfaces Status - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Ethernet Port Commands

show interfaces status

Displays interface line settings (e.g., speed and mode).
show interfaces [slot | slot/port[-port2]] status
Syntax Definitions
slot
port
port2
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
If no slot/port numbers are entered, line settings for all slots/ports on the switch are displayed.
Examples
-> show interfaces 1/2 status
Slot/ Admin Auto
Port Status Nego
------+------+----+--------+------+-------+--------+------+-------+-----
1/1 dis
output definitions
Slot/Port
Admin Status
AutoNego
Detected Speed
Detected Duplex
Detected Pause
Configured Speed
Configured Duplex
Configured Pause
Link Trap
OmniSwitch CLI Reference Guide
Slot number you want to display.
Port number of the interface you want to display.
Last port number in a range of ports you want to display.
DETECTED-VALUES
Speed Duplex
(Mbps)
en - -
Interface slot/port number.
The administrative status of the port.
Autonegotiation status (Enable/Disable).
Detected line speed in Mbps.
Detected line duplex (Half duplex/Full duplex/Auto).
Detected pause control configuration.
Configured line speed (10/100/Auto/1000/10000 Mbps).
Configured line duplex (Half duplex/Full duplex/Auto).
Detected pause control configuration.
Link Trap status.
March 2011
CONFIGURED-VALUES
Pause Speed Duplex
(Mbps)
- Auto Auto
show interfaces status
Pause Link
Trap
- dis
page 1-29