Mac-Learning Vlan Multicast Mac-Address - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

mac-learning vlan multicast mac-address

mac-learning vlan multicast mac-address
Configures a static multicast MAC address and assigns the address to one or more egress ports. Packets
received on ports associated with the specified VLAN that contain a destination MAC address that
matches the static multicast address are forwarded to the specified egress ports. Static multicast MAC
addresses are maintained in the Source Learning MAC address table.
mac-learning vlan vlan_id { port slot/port| linkagg linkagg_id } multicast mac-address
multicast_address [group group_id]
no mac-learning {vlan vlan_id [port slot/port | linkagg linkagg_id ]} {multicast [mac-address
multicast_address]}
Syntax Definitions
vlan_id
slot/port
linkagg_id
multicast_address
group_id
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove a static multicast MAC address from the Source Learning
MAC Address Table. Note that if no parameters are specified with this form of the command, then all
static multicast addresses are removed.
•
Note that a MAC address is considered a multicast MAC address if the least significant bit of the most
significant octet of the address is enabled. For example, MAC addresses with a prefix of 01, 03, 05, 13,
and so on, are multicast MAC addresses.
•
If a multicast prefix value is not present, then the address is treated as a regular MAC address and not
allowed when using the mac-learning vlan multicast mac-address command. Also note that
multicast addresses within the following ranges are not supported:
01:00:5E:00:00:00 to 01:00:5E:7F:FF:FF
01:80:C2:XX.XX.XX
33:33:XX:XX:XX:XX
page 3-6
VLAN ID number.
The egress slot and port combination that is assigned to the static
multicast MAC address.
Enter a link aggregate ID number. See
Commands."
Enter the destination multicast MAC Address to add to the MAC
Address Table (for example, 01:00:39:59:f1:0c).
This keyword cannot be user defined.
Source Learning Commands
Chapter 6, "Link Aggregation
OmniSwitch CLI Reference Guide March 2011