Linkagg Static Agg Size - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Link Aggregation Commands

linkagg static agg size

Creates a static aggregate group between two switches. A static aggregate group contains static links.
linkagg static agg agg_num1 [-agg_num2] size size [name name] [admin-state {enable | disable}]
[multi-chassis active]
no linkagg static agg agg_num1 [-agg_num2]
Syntax Definitions
agg_num1
-agg_num2
size
name
enable
disable
multi-chassis active
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove a static aggregate group or a range of static aggregate
groups from the configuration.
•
If the static aggregate has any attached ports you must delete the attached ports with the no form of the
linkagg static port agg
ports using the no linkagg static port command.
•
Use the multi-chassis active parameter to activate a static link aggregate group between multiple
switch chassis. This parameter is used only in a multi-chassis link aggregation (MC-LAG) configura-
tion.
•
Use the linkagg lacp agg size
OmniSwitch CLI Reference Guide
The number corresponding to the static aggregate group.
The last link aggregate ID in a range of link aggregate IDs.
The maximum number of links allowed in the aggregate group.
The name of the static aggregate group. Can be any alphanumeric
string. Spaces must be contained within quotes (for example, "Static
Group 1").
Specifies that the static aggregate group is active and is able to
aggregate links.
Specifies that the static aggregate group is inactive and not able to
aggregate links.
Specifies that the multi-chassis link aggregate feature should be acti-
vated on the static aggregate group between the two switches.
default
enable
command before you remove the static link aggregate ID. Delete the attached
command to create a dynamic aggregation (LACP) group.
March 2011
linkagg static agg size
page 6-3