Traceroute - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

IP Commands

traceroute

Finds the path taken by an IP packet from the local switch to a specified destination. This command
displays the individual hops to the destination as well as some timing information.
traceroute {ip_address | hostname} [max-hop max_hop_count] [min-hop min_hop_count] [source-
interface ip_interface] [probes probe_count] [timeout seconds] [port port_number_value]
Syntax Definitions
ip_address
hostname
max_hop_count
min_hop_count
source-interface ip_interface
probes probe_count
timeout seconds
port port_number_value
Defaults
parameter
max-hop max_hop_count
min-hop min_hop_count
source-interface ip_interface
probes probe_count
timeout seconds
port port_number_value
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
When using this command, you must enter the name of the destination as part of the command line
(either the IP address or host name).
Examples
-> traceroute 128.251.17.224
traceroute to 128.251.17.224, 30 hops max, 40 byte packets
1 10.255.11.254 0 ms
2 172.23.0.251 0 ms
OmniSwitch CLI Reference Guide
IP address of the host whose route you want to trace.
DNS name of the host whose route you want to trace.
Maximum hop count for the trace. The valid range is 1–255.
Minimum hop count for the trace. The valid range is 1–30.
Source IP interface to be used in the traceroute packets.
The number of packets (retry) that will be sent for each hop-count. The
valid range is 1–10000.
The time to wait for the response of each probe packet.
The destination port number to be used in the probing packets.
default
30
1
Outgoing IP
interface as per
route lookup
3
5
33334
0 ms 0 ms
16.6667 ms 0 ms
March 2011
traceroute
page 10-19