Vlan Members Untagged - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

vlan members untagged

vlan members untagged
Configures a new default VLAN for a single port or an aggregate of ports. The VLAN specified with this
command is referred to as the configured default VLAN for the port.
vlan vlan_id [-vlan_id2] members {port slot/port[-port1] | linkagg linkagg_id[-linkagg_id2]} untagged
no vlan vlan_id [-vlan_id2] members {port slot/port[-port1]| linkagg_id linkagg_id[-linkagg_id2]}
Syntax Definitions
vlan_id
slot/port[-port1]
linkagg_id[-linkagg_id2]
Defaults
VLAN 1 is the default VLAN for all ports.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove a port or link aggregate from its configured default VLAN
and restore VLAN 1 as the default VLAN.
•
The VLAN ID and link aggregate ID specified with this command must already exist in the switch
configuration.
•
This command configures the port or link aggregate to send and receive untagged packets for the speci-
fied VLAN ID, which becomes the default VLAN of the port.
•
Every switch port or link aggregate has only one configured default VLAN. The 802.1Q tagged ports,
however, can have additional VLAN assignments, which are often referred to as secondary VLANs.
Examples
-> vlan 20 members port 4/1-24 tagged
-> vlan 20 members linkagg 2-4 untagged
-> no vlan 1-4 members port 4/1-24
-> no vlan 20 members linkagg 2-4
Release History
Release 7.1.1; command introduced.
page 4-4
An existing VLAN ID number of the VLAN to assign as the default
VLAN configured for the port.
The slot number for the module and the physical port number
(for example, 3/1 specifies port 1 on slot 3) or a range of physical port
numbers on that module (for example, 3/1-16).
The link aggregate ID number or range of IDs to be assigned to the
specified VLAN.
VLAN Management Commands
OmniSwitch CLI Reference Guide March 2011