Ip Route-Map Match Ipv6-Interface - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

IP Commands

ip route-map match ipv6-interface

Matches the IPv6 interface name specified in the route map with the one that the routing protocol learned
the route on.
ip route-map route-map-name [sequence-number number] match ipv6-interface interface-name
no ip route-map route-map-name [sequence-number number] match ipv6-interface interface-name
Syntax Definitions
route-map-name
number
interface-name
Defaults
parameter
number
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to delete the match ipv6-interface parameter in the route map.
•
All route maps having the same name but different sequence numbers are linked together and
processed in order of increasing sequence number.
•
The route-map-name and sequence-number must exist before you configure this match criteria.
Examples
-> ip route-map route1 sequence-number 10 match ipv6-interface int6
-> no ip route-map route1 sequence-number 10 match ipv6-interface int6
Release History
Release 7.1.1; command introduced
Related Commands
ip route-map action
show ip route-map
OmniSwitch CLI Reference Guide
The name of the route map.
A number that links together the route maps. The range is 1–100.
Specifies the interface name of the outgoing interface of the route.
default
50
Creates a route map for redistribution and sets the status of the route
map to permit or deny.
Displays the configured IP route maps.
March 2011
ip route-map match ipv6-interface
page 10-45