multi-chassis ipc-vlan
multi-chassis ipc-vlan
Configures the multi-chassis control VLAN on the switch. The multi-chassis control VLAN must be
configured with the same values on the switches that will operate in multi-chassis mode.
multi-chassis ipc-vlan vid
Syntax Definitions
vlan
Defaults
parameter
vlan
(Multi-chassis control VLAN)
Platforms Supported
OmniSwitch 10K
Usage Guidelines.
•
This command can be executed only if a valid multi-chassis chassis identifier within the range [1 - 2] is
configured on the switch at that time.
•
The multi-chassis control VLAN parameter must match between switches configured to operate in
multi-chassis mode for the feature to be operational.
•
A switch reboot or reset is required for the configured multi-chassis control VLAN parameters to
become operational. In other words, any configuration to these parameters are implemented only after
the next reset of the switch.
•
The VLAN configured as multi-chassis control VLAN is shown as a different VLAN type.
•
No front-panel ports (user ports) can be manually configured as members of the multi-chassis control
VLAN and that VLAN cannot be disabled.
•
Spanning tree configuration commands are not allowed on the multi-chassis control VLAN.
•
VLAN 1 is not allowed to be configured as the multi-chassis control VLAN.
Examples
-> multi-chassis ipc-vlan 4094
Release History
Release 7.1.1; command introduced.
page 7-8
Multi-chassis control VLAN used for all multi-chassis control
communication between the peer switches within the range [2 - 4094].
default
4094
Multi-Chassis Commands
OmniSwitch CLI Reference Guide
March 2011