Spantree Mst Region Name - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

spantree mst region name

spantree mst region name
Defines the name for a Multiple Spanning Tree (MST) region. One of three attributes (name, revision
level, and a VLAN to MST instance association table) that defines an MST region as required by the IEEE
802.1Q 2005 standard. Switches that share the same attribute values are all considered part of the same
MST region. Currently each switch can belong to one MST region at a time.
spantree mst region name name
no spantree mst region name
Syntax Definitions
name
Defaults
By default, the MST region name is left blank.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove the MST region name.
Note. It is not necessary to specify the region name to remove it.
•
To change the existing region, use this command with a string value that is different than the existing
region name.
•
Specifying an MST region name is allowed regardless of which Spanning Tree operating mode or
protocol is currently active on the switch. However, MST configuration values, such as region name,
only apply when the switch is operating in the flat Spanning Tree mode and using MSTP.
Examples
-> spantree mst region name SalesRegion
-> spantree mst region name "Alcatel-Lucent Marketing"
-> no spantree mst region name
Release History
Release 7.1.1; command introduced.
page 5-8
An alphanumeric string. Use quotes around string if the name contains
multiple words with spaces between them (for example "Alcatel-Lucent
Marketing").
Distributed Spanning Tree Commands
OmniSwitch CLI Reference Guide March 2011