Multi-Chassis Vf-Link Create - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

multi-chassis vf-link create

multi-chassis vf-link create
Configures a virtual fabric link between two peer switches to enable them to operate in multi-chassis
mode.
multi-chassis vf-link create
no multi-chassis vf-link
Syntax Definitions
NA
Defaults
NA
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command can be executed only if a valid multi-chassis chassis identifier within the range [1 - 2] is
configured on the switch at that time.
•
Although the switch supports runtime configuration of the virtual fabric link and its member ports, it is
recommended to configure the virtual fabric link at the same time the chassis identifier is configured
and before rebooting the switches in multi-chassis mode.
Examples
-> multi-chassis vf-link create
-> no multi-chassis vf-link
Release History
Release 7.1.1; command introduced.
Related Commands
multi-chassis vf-link member-
port
multi-chassis vf-link default-
vlan
show multi-chassis vf-link
show multi-chassis vf-link
member-port
page 7-14
Adds a port to the list of member ports of the virtual fabric link.
Configures the default VLAN on the virtual fabric link.
Displays a summary of the configured and operational parameters
related to the virtual fabric link on the switch.
Displays detailed information about the configured and operational
parameters related to the virtual fabric link member ports on the switch.
Multi-Chassis Commands
OmniSwitch CLI Reference Guide March 2011