linkagg static port agg
linkagg static port agg
Configures a slot and port for a static aggregate group.
linkagg static port slot/port[-port2] agg agg_num
no linkagg static port slot/port[-port2]
Syntax Definitions
slot
port
-port2
agg_num
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove one or more ports from a static aggregate group.
•
A port can belong to only one aggregate group.
•
Ports that belong to the same static aggregate group need not be configured sequentially and can be on
any Network Interface (NI).
•
To specify a range of link aggregates, use hyphen between the first and last link aggregate IDs of the
range. A range of link aggregate IDs can be used only with the no form of this command.
Examples
-> linkagg static port 2/1-5 agg 4
-> no linkagg static port 2/1-5
Release History
Release 7.1.1; command introduced.
page 6-8
The slot number for this aggregate.
The port that the switch initially uses as the Spanning Tree virtual port
for this aggregate.
The last port number in a range of port IDs.
The number corresponding to the static aggregate group.
Link Aggregation Commands
OmniSwitch CLI Reference Guide
March 2011