Udld Echo-Wait-Timer - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

UDLD Commands

udld echo-wait-timer

Configures the echo based detection timer on a specific port, a range of ports, or all the ports. This is
known as link detection period.
udld port [slot/port[-port2]] echo-wait-timer seconds
no udld port [slot/port[-port2]] echo-wait-timer
Syntax Definitions
slot/port
port2
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to reset the echo based detection timer to the default value. Note that
it is not necessary to specify the echo based timer to reset it.
•
The UDLD protocol must be enabled before using this command.
•
An echo message is expected in reply from the neighbor within this time duration, otherwise, the port
is considered as faulty.
Examples
-> udld echo-wait-timer 9
-> udld port 1/5 echo-wait-timer 12
-> udld port 1/7-16 echo-wait-timer 12
-> no udld echo-wait-timer
-> no udld port 1/3 echo-wait-timer
Release History
Release 7.1.1; command introduced.
OmniSwitch CLI Reference Guide
The slot number for the module and the physical port number on that
module (for example, 3/1 specifies port 1 on slot 3).
The last port number in a range of ports that you want to configure on
the same slot (for example, 3/1-4 specifies ports 1-4 on slot 3).
The echo based detection period, in seconds.
default
8
March 2011
udld echo-wait-timer
page 2-9