Interfaces Flood-Limit - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

interfaces flood-limit

interfaces flood-limit
Configures the flood rate settings on a single port, a range of ports, or an entire Network Interface (NI).
interfaces {slot| slot/port[-port2]} flood-limit {bcast|mcast|uucast|all} rate { pps pps_num| mbps
mbps_num | cap% cap_num | enable | disable}
Syntax Definitions
slot
port
port2
bcast
mcast
uucast
all
pps_num
mbps_num
cap_num
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
N/A
page 1-14
Slot number you want to configure.
Port number of the interface you want to configure.
Last port number in a range of ports you want to configure.
Specifies broadcast flood limit.
Specifies multicast flood limit.
Specifies unicast flood limit.
Specifies flood limit for all types of traffic.
Packets per second.
Megabits per second.
Percentage of port's capacity.
Enables flood rate limits.
Disables flood rate limits.
default
enable
Ethernet Port Commands
OmniSwitch CLI Reference Guide March 2011