Linkagg Lacp Port Actor Admin-State - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Link Aggregation Commands

linkagg lacp port actor admin-state

Configures the system administrative state of the slot and port for the dynamic aggregate group on the
local switch. The state values correspond to bits in the actor state octet in the LACPDU frame.
linkagg lacp port slot/port[-port2] actor admin-state {[active] [timeout] [aggregate] [synchronize]
[collect] [distribute] [default] [expire] | none}
no linkagg lacp port slot/port[-port2] actor admin-state {[active] [timeout] [aggregate] [synchronize]
[collect] [distribute] [default] [expire] | none}
Syntax Definitions
slot
port
-port2
active
timeout
aggregate
synchronize
collect
distribute
default
OmniSwitch CLI Reference Guide
The slot number for this aggregate.
The port that the switch initially uses as the Spanning Tree virtual port
for this aggregate.
The last port number in a range of port IDs.
Specifies that bit 0 in the actor state octet is enabled. When this bit is
set, the dynamic aggregate group is able to exchange LACPDU frames.
By default, this value is set.
Specifies that bit 1 in the actor state octet is enabled. When this bit is
set, a short timeout is used for LACPDU frames. When this bit is
disabled, a long timeout is used for LACPDU frames. By default, this
value is set.
Specifies that bit 2 in the actor state octet is enabled. When this bit is
set, the system considers this port to be a potential candidate for
aggregation. If this bit is not enabled, the system considers the port to be
individual (it can only operate as a single link). By default, this value is
set.
Specifying that this keyword has no effect because the system always
determines its value. When this bit (bit 3) is set by the system, the port
is allocated to the correct dynamic aggregation group. If this bit is not
set by the system, the port is not allocated to the correct dynamic aggre-
gation group.
Specifying that this keyword has no effect because the system always
determines its value. When this bit (bit 4) is set by the system, incom-
ing LACPDU frames are collected from the individual ports that make
up the dynamic aggregate group.
Specifying that this keyword has no effect because the system always
determines its value. When this bit (bit 5) is set by the system, distribut-
ing outgoing frames on the port is disabled.
Specifying that this keyword has no effect because the system always
determines its value. When this bit (bit 6) is set by the system, it indi-
cates that the actor is using the defaulted partner information adminis-
tratively configured for the partner.
March 2011
linkagg lacp port actor admin-state
page 6-31