UDLD Commands
udld mode
Configures the operational mode of UDLD on a specific port, a range of ports, or all the ports.
udld port [slot/port[-port2]] mode {normal | aggressive}
Syntax Definitions
slot/port
port2
normal
aggressive
Defaults
parameter
normal | aggressive
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
The UDLD protocol must be enabled before using this command.
•
The UDLD protocol is not supported on aggregate ports.
•
In case of faulty cable connection, the port which is configured in normal mode of operation is
considered to be in the shutdown state.
Examples
-> udld mode aggressive
-> udld mode normal
-> udld port 1/3 mode aggressive
-> udld port 2/4 mode normal
-> udld port 2/9-18 mode aggressive
Release History
Release 7.1.1; command introduced.
OmniSwitch CLI Reference Guide
The slot number for the module and the physical port number on that
module (for example, 3/1 specifies port 1 on slot 3).
The last port number in a range of ports that you want to configure on
the same slot (for example, 3/1-4 specifies ports 1-4 on slot 3).
Specifies UDLD operation in the normal mode.
Specifies UDLD operation in the aggressive mode.
default
normal
March 2011
udld mode
page 2-5