Spantree Vlan Connection - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Omniswitch series
Table of Contents

Advertisement

Distributed Spanning Tree Commands

spantree vlan connection

Configures the connection type for a port or a link aggregate of ports for a VLAN instance.
spantree vlan vlan_id {port slot/port [-port2] | linkagg linkagg_id [-linkagg_id2]} connection {noptp |
ptp | autoptp}
Syntax Definitions
vlan_id
slot/port[-port2]
linkagg_id[-linkagg_id2]
noptp
ptp
autoptp
Defaults
By default, the link connection type is set to auto point-to-point.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
This command only applies to the specified VLAN instance regardless of which operating mode (flat
or per-VLAN) is active for the switch.
If the switch is running in the flat mode when this command is used, the specified connection type for
the port is not active for the specified VLAN instance until the operating mode for the switch is
changed to the per-VLAN mode.
A port is considered connected to a point-to-point LAN segment if the port belongs to a link aggregate
of ports or if autonegotiation determines the port must run in full duplex mode or if full duplex mode
was administratively set. Otherwise, the port is considered connected to a no point-to-point LAN
segment.
Rapid transition of a designated port to forwarding can only occur if the port connection type is defined
as a point to point or an edge port. Rapid transition of an alternate port role to a root port role is not
affected by the port connection type definition.
OmniSwitch CLI Reference Guide
An existing VLAN ID number.
The slot number and port number of the physical port. Use a hyphen to
specify a range of ports (4/1-8).
The link aggregate ID number. Use a hyphen to specify a range of IDs
(10-20).
Defines port connection type as no point-to-point link.
Defines port connection type as point-to-point link.
Specifies that switch software automatically defines connection type as
point-to-point or no point-to-point and whether or not the port is an
edge port.
March 2011
spantree vlan connection
page 5-53

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Omniswitch 10k

Table of Contents