multi-chassis vf-link default-vlan
multi-chassis vf-link default-vlan
Configures the default VLAN on the virtual fabric link.
multi-chassis vf-link default-vlan vlan
no multi-chassis vf-link default-vlan vlan
Syntax Definitions
vlan
Defaults
parameter
vlan
(Virtual fabric-link default-vlan)
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command can be executed only if a valid multi-chassis chassis identifier within the range [1 - 2] is
configured on the switch at that time.
•
When no configuration is explicitly provided, the default or untagged VLAN on the virtual fabric link
is VLAN 1.
•
A VLAN must be created in advance using the vlan command to allow the VLAN as the default
VLAN on the virtual fabric link.
•
If the VLAN currently configured as the default VLAN on the virtual fabric link is removed using
VLAN management command ( vlan vid ) its configured value is reset to the default value correspond-
ing to VLAN 1.
Examples
-> vlan 2 admin-state enable
-> multi-chassis vf-link default-vlan 2
-> no multi-chassis vf-link default-vlan
-> no vlan 2
Release History
Release 7.1.1; command introduced.
page 7-18
VLAN to be configured as the default VLAN on the virtual fabric link
in the range [1 - 4094].
default
1
Multi-Chassis Commands
OmniSwitch CLI Reference Guide
March 2011