spantree vlan txholdcount
spantree vlan txholdcount
This command is used to rate limit the transmission of BPDU through a given port for the VLAN instance.
spantree vlan vlan_id txholdcount {value}
Syntax Definitions
vlan_id
value
Defaults
By default, the txholdcount value is set to 3.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command only applies to the specified VLAN instance regardless of which operating mode (flat
or per-VLAN) is active for the switch.
•
If the switch is running in the flat mode when this command is used, the specified txholdcount status
for the port is not active for the VLAN instance until the switch is running in the per-VLAN Spanning
Tree mode.
Examples
-> spantree vlan 3 txholdcount 6
Release History
Release 7.1.1; command introduced.
Related Commands
spantree mode
spantree cist txholdcount
MIB Objects
vStpInsTable
vStpInsBridgeTxHoldCount
page 5-72
An existing VLAN ID number.
A numeric value that controls the transmission of BPDU through the
port. The valid range is 1–10.
Selects the Spanning Tree operating mode (flat or per-VLAN) for the
switch.
Configures the BPDU transmission rate limit for the CIST instance.
Distributed Spanning Tree Commands
OmniSwitch CLI Reference Guide
March 2011