Ip Route-Map Set Metric-Type - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

IP Commands

ip route-map set metric-type

Configures the metric type for the redistributed route.
ip route-map route-map-name [sequence-number number] set metric-type
{internal | external [type1 | type2]}
no ip route-map route-map-name [sequence-number number] set metric-type
{internal | external [type1 | type2]}
Syntax Definitions
route-map-name
number
internal
external
type1
type2
Defaults
parameter
number
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to delete the set metric-type parameter in the route map.
•
All route maps having the same name but different sequence numbers are linked together and
processed in order of increasing sequence number.
•
The route-map-name and sequence-number must exist before you configure this set criteria.
Examples
-> ip route-map 111 sequence-number 50 set metric-type internal
-> no ip route-map 111 sequence-number 50 set metric-type internal
Release History
Release 7.1.1; command introduced
OmniSwitch CLI Reference Guide
The name of the route map.
A number that links together the route maps. The range is 1–100.
Sets the metric type to internal for routes redistributed into BGP.
Sets the metric type to external for routes redistributed into BGP.
Sets the metric type to external type1 for routes redistributed into OSPF,
which gives the full metric calculation for the complete path including
internal as well as external cost.
Sets the metric type to external type2 for routes redistributed into OSPF,
which gives the external redistribution metric only to the ASBR.
default
50
March 2011
ip route-map set metric-type
page 10-53