Show Spantree Cist - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show spantree cist

show spantree cist
Displays the Spanning Tree bridge configuration for the flat mode Common and Internal Spanning Tree
(CIST) instance.
show spantree cist
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guideline
This command displays Spanning Tree bridge information for the flat mode CIST instance regardless of
which mode (per-VLAN or flat) is active on the switch. Note that minimal information is displayed when
this command is used in the per-VLAN mode, as the CIST is not active in this mode. See second example
below.
Examples
-> spantree mode flat
-> show spantree cist
Spanning Tree Parameters for Cist
Spanning Tree Status :
Protocol
mode
Auto-Vlan-Containment:
Priority
Bridge ID
CST Designated Root
Cost to CST Root
Next CST Best Cost
Designated Root
Cost to Root Bridge
Root Port
Next Best Root Cost
Next Best Root Port
TxHoldCount
Topology Changes
Topology age
Current Parameters (seconds)
Max Age
Forward Delay
Hello Time
Parameters system uses when attempting to become root
System Max Age
System Forward Delay =
page 5-76
: IEEE Multiple STP,
: FLAT (Single STP),
Enabled
: 32768 (0x8000),
: 8000-00:d0:95:01:39:2c,
: 8000-00:d0:95:01:39:2c,
:
:
: 8000-00:d0:95:01:39:2c,
:
: None,
:
: None,
:
:
: 00:00:00,
= 20,
= 15,
= 2
= 20,
20,
Distributed Spanning Tree Commands
ON,
,
0,
0,
0,
0,
3,
0,
OmniSwitch CLI Reference Guide March 2011