Show Ipv6 Ospf Interface - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show ipv6 ospf interface

show ipv6 ospf interface
Displays OSPFv3 interface information.
show ipv6 ospf interface [interface_name]
Syntax Definitions
interface_name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Not specifying the interface name displays all known interfaces for the OSPFv3 router.
Examples
-> show ipv6 ospf interface
Name DR Router ID
----------+----------------+---------------+----------+---------+---------
vlan-2071 5.5.5.5
vlan-2055 7.7.7.7
vlan-2056 7.7.7.7
output definitions
Name
DR Router ID
BDR Router ID
Vlan
Admin Status
Oper Status
State
page 18-42
The name of the interface.
Admin
BDR Router ID Status
0.0.0.0 Enabled
5.5.5.5 Enabled
5.5.5.5 Enabled
The name of the interface.
The designated router address on this network segment. Make sure you
configure a VLAN for the router IP. (See
ment Commands," for more information.)
The IP address of the backup designated router.
The VLAN to which the interface is assigned.
The current administration status of the interface, either enabled or
disabled.
Indicates whether the interface is an active OSPF interface.
The current state of the OSPF interface. It will be DR, BDR, other.
Oper
Status State
Up
Up
Up
Chapter 4, "VLAN Manage-
OmniSwitch CLI Reference Guide
OSPFv3 Commands
DR
BDR
BDR
March 2011