Show Linkagg - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Link Aggregation Commands

show linkagg

Displays information about static and dynamic (LACP) aggregate groups.
show linkagg {agg [agg_num1 [-agg_num2]}
Syntax Definitions
agg_num1
-agg_num2
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
If no aggregation number is specified, information for all aggregate groups is displayed. If an
aggregate number is specified, only the information about the relevant aggregate group is displayed.
The fields included in the display depend on whether the aggregate group is a static or dynamic.
•
Use the show linkagg port command to display information about aggregate group ports.
Examples
No aggregate group is specified:
-> show linkagg
Number Aggregate
-------+----------+--------+----+-------------+-------------+--------+-----
1 Static
2 Dynamic
3 Dynamic
4 Dynamic
5 Static
Output fields are defined here:
output definitions
Number
Aggregate
SNMP Id
Size
OmniSwitch CLI Reference Guide
Specifies the aggregate group. Configured through the linkagg static
agg size or linkagg lacp agg size command.
The last link aggregate ID in a range of link aggregate IDs.
SNMP Id Size Admin State
40000001 8 ENABLED
40000002 4 ENABLED
40000003 8 ENABLED
40000004 8 ENABLED
40000005 2 DISABLED
The aggregate group number.
The type of aggregate group, which can be Static or Dynamic.
The SNMP ID associated with the aggregate group.
The number of links in this aggregate group.
March 2011
Oper State Att/Sel Ports
UP 2
DOWN 0
DOWN 0
UP 3
DOWN 0
show linkagg
2
0
2
3
0
page 6-53