show interfaces ingress-rate-limit
show interfaces ingress-rate-limit
Displays the ingress-rate-limit set for each interface port.
show interfaces [slot| slot/port[-port1]] ingress-rate-limit
Syntax Definitions
slot
port
port1
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
If the slot number is not specified, then the switch back pressure feature must be enabled or disabled on an
entire chassis.
Examples
-> show interfaces 1/1-4 ingress-rate-limit
Slot/ Rate Limit Burst Size Status
Port
(Mbps)
------+----------+----------+-------
1/1
496
1/2
496
1/3
496
1/4
496
output definitions
Slot/Port
Rate Limit (Mbps)
Burst Size (MB)
Status
Release History
Release 7.1.1; command introduced.
page 1-44
Slot number you want to display.
Port number of the interface you want to display.
Last port number in a range of ports you want to display.
(MB)
19
disable
19
disable
19
disable
19
disable
Interface slot and port numbers.
Rate limit in Megabits.
Burst size in Megabytes.
Status of rate limiting.
Ethernet Port Commands
OmniSwitch CLI Reference Guide
March 2011