Show Interfaces Status - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet Port Commands

show interfaces status

Displays interface line settings (for example, speed and mode).
show interfaces [slot | slot/port[-port2]] status
Syntax Definitions
slot
slot/port[-port2]
Defaults
By default, line settings are displayed for all ports on all modules.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Enter a slot number to display information for all interfaces on that slot.
•
Enter a slot and port number or a range of port numbers to display information for a specific interface
or a range of interfaces.
Examples
The following is an example for a non combo port:
-> show interfaces 1/2 status
Slot/ AutoNego
Port (Mbps)
-----+--------+------+------+------+--------+------+------+------
1/2 Enable
The following is an example for a combo port:
-> show interfaces 1/47 status
Slot/ AutoNego
Port (Mbps)
-----+--------+------+------+------+--------+------+------+------
1/47 Enable
1/47 Enable
FF - ForcedFiber PF - PreferredFiber
FC - ForcedCopper PC - PreferredCopper C - Copper
OmniSwitch CLI Reference Guide
The slot number for a specific module.
The slot and port number (3/1). Use a hyphen to specify a range of ports
(3/1-3/10).
DETECTED
Speed Duplex Hybrid
Type
1000 Full NA
DETECTED
Speed Duplex Hybrid
Type
- - -
- - -
June 2012
CONFIGURED
Speed Duplex Hybrid
(Mbps) Mode
Auto Auto NA
CONFIGURED
Speed Duplex Hybrid
(Mbps) Mode
1000 Full PF
Auto Auto PF
F - Fiber
Trap
LinkUpDown
-
Trap
LinkUpDown
-
-
page 1-87