Spantree Cist Txholdcount - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Distributed Spanning Tree Commands

spantree cist txholdcount

This command is used to rate limit the transmission of BPDU through a given port for the flat mode
Common and Internal Spanning Tree (CIST) instance.
spantree cist txholdcount value
Syntax Definitions
value
Defaults
By default, the txholdcount value is set to 3.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command only applies to the CIST instance regardless of which operating mode (flat or per-
VLAN) is active for the switch.
•
If the switch is running in the per-VLAN mode when this command is used, the specified txholdcount
status for the port is not active for the CIST instance until the switch is running in the flat Spanning
Tree mode.
Examples
-> spantree cist txholdcount 5
Release History
Release 7.1.1; command introduced.
Related Commands
spantree mode
spantree vlan txholdcount
MIB Objects
vStpInsTable
vStpInsBridgeTxHoldCount
OmniSwitch CLI Reference Guide
A numeric value that controls the transmission of BPDU through the
port. The valid range is 1–10.
Selects the Spanning Tree operating mode (flat or per-VLAN) for the
switch.
Configures the BPDU transmission rate limit for the specified VLAN
instance.
March 2011
spantree cist txholdcount
page 5-71