Lldp Tlv Management - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

802.1AB Commands

lldp tlv management

Specifies the switch to control per port management TLVs to be incorporated in the LLDPDUs.
lldp {port slot/port [-port ] | slot slot | chassis} tlv management {port-description | system-name |
system-description | system-capabilities | management-address} {enable | disable}
Syntax Definitions
slot/port
slot
port-description
system-name
system-description
system-capabilities
management-address
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
The LLDPDU must be enabled and set to transmit before using this command.
•
If this command is applied to a slot or chassis, then the existing configuration related to this command
is lost.
Examples
-> lldp port 1/2 tlv management port-description enable
-> lldp slot 2 tlv management management-address enable
-> lldp slot 3 tlv management system-name disable
-> lldp chassis tlv management system-capabilities enable
OmniSwitch CLI Reference Guide
Slot number for the module and physical port number on that module
(e.g., 3/1 specifies port 1 on slot 3).
The slot number for a specific module.
Enables or disables the transmission of port description TLV in
LLDPDU.
Enables or disables the transmission of system name TLV in LLDPDU.
Enables or disables transmission of system description TLV in
LLDPDU.
Enables or disables transmission of system capabilities TLV in
LLDPDU.
Enables or disables transmission of management address on per port.
Enables management TLV LLDPDU transmission.
Disables management TLV LLDPDU transmission.
default
disable
March 2011
lldp tlv management
page 9-11