Icmp Addr-Mask - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

icmp addr-mask

icmp addr-mask
Enables or disables ICMP address mask messages, and sets the minimum packet gap. The minimum
packet gap is the number of microseconds that must pass between ICMP messages of the same type.
icmp add-mask [request | reply] {{enable | disable} | min-pkt-gap gap}
Syntax Definitions
request
reply
enable
disable
gap
Defaults
parameter
enable | disable
gap
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
A gateway receiving an address mask request must return it with the address mask field set to the
32-bit mask of the bits identifying the subnet and network, for the subnet on which the request was
received.
•
Using this command without specifying a request or reply enables, disable, or set the minimum packet
gap for both types.
•
The address mask ICMP messages can also be enabled, disabled, and modified using the
command. See the
messages.
Examples
-> icmp addr-mask reply enable
-> icmp addr-mask enable
-> icmp addr-mask request enable
-> icmp addr-mask request min-pkt-gap 50
Release History
Release 7.1.1; command introduced
page 10-84
Specifies request address mask messages.
Specifies reply address mask messages.
Enables the specified ICMP message.
Disables the specified ICMP message.
The number of microseconds required between ICMP messages of this
type.
default
enable
0
icmp type command information on the type and code for the address mask ICMP
OmniSwitch CLI Reference Guide
IP Commands
icmp type
March 2011