show spantree mode
show spantree mode
Displays the current global Spanning Tree mode parameter values for the switch.
show spantree mode
Syntax Definition
NA
Defaults
NA
Platforms Supported
OmniSwitch 10K
Usage Guidelines
The global parameters for spanning tree can be activated or configured using the related commands.
Examples
-> show spantree mode
Spanning Tree Global Parameters
Current Running Mode
Current Protocol
Path Cost Mode
Auto Vlan Containment : N/A
Cisco PVST+ mode
Vlan Consistency check
output definitions
Current Running Mode
Current Protocol
Path Cost Mode
Auto Vlan Containment
Cisco PVST+ mode
Vlan Consistency check
page 5-108
: Per VLAN,
: N/A (Per VLAN),
: 32 BIT,
: Disabled
: Disabled
The spantree mode active on the switch. (Flat or Per VLAN)
The spantree protocol active on the switch.
The path cost mode value configured on the switch. (AUTO or 32 BIT)
The Auto VLAN containment mode configured on the switch
(Enabled or Disabled).
The PVST+ mode configured on the switch (Enabled or Disabled).
Specifies if VLAN consistency check is Enabled or Disabled on the
switch.
Distributed Spanning Tree Commands
OmniSwitch CLI Reference Guide
March 2011