Multi-Chassis Chassis-Id Hello-Interval Ipc-Vlan - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

multi-chassis chassis-id hello-interval ipc-vlan

multi-chassis chassis-id hello-interval ipc-vlan
Configures the multi-chassis feature parameters on the switch. A chassis identifier within the range [1 - 2]
must be configured in order for the multi-chassis feature to become operational. Optionally, the multi-
chassis control VLAN and hello interval may be configured. The multi-chassis control VLAN and hello
interval must be configured with the same values on the switches that will operate in multi-chassis mode.
multi-chassis chassis-id chassis_id [hello-interval interval][ ipc-vlan vlan]
Syntax Definitions
chassis_id
interval
vlan
Defaults
parameter
chassis_id
interval
vlan
(Multi-chassis control VLAN)
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
The hello interval and multi-chassis control VLAN parameters must match between switches config-
ured to operate in multi-chassis mode for the feature to be operational.
•
A switch reboot or reset is required for the configured hello interval and multi-chassis control VLAN
parameters to become operational. In other words, any configuration to these parameters are imple-
mented only after the next reset of the switch.
•
The VLAN configured as multi-chassis control VLAN is shown as a different VLAN type.
•
The IPC-VLAN is shown as a different VLAN type.
•
No front-panel ports (user ports) can be manually configured as members of the multi-chassis control
VLAN and that VLAN cannot be disabled.
•
Spanning tree configuration commands are not allowed on the multi-chassis control VLAN.
•
VLAN 1 is not allowed to be configured as the multi-chassis control VLAN.
page 7-4
Chassis identifier within the multi-chassis operational range [1 - 2].The
chassis identifier must be globally unique within the set of switches
configured to operate together providing multi-chassis services.
Time interval, in seconds, at which multi-chassis control hello messages
are to be sent to the peer switch within the range [1 - 10].
Multi-chassis control VLAN used for all multi-chassis control commu-
nication between the peer switches within the range [2 - 4094].
default
0 (standalone or no multi-chassis operation allowed)
1 second
4094
Multi-Chassis Commands
OmniSwitch CLI Reference Guide March 2011